中文 English

新闻资讯

NEWS INFORMATION

Safety operation procedures for ultrasonic cleaners

1. The surrounding environment of the cleaning machine should be clean, dry and free of strong corrosive gas, and avoid violent vibration.

2. There should be enough space for heat dissipation on the back of the generator.

3. Make sure the machine has good grounding to avoid personal injury accidents.

4. When the cleaning

machine is working, do not immerse your fingers in the cleaning solution.

5. It is strictly forbidden to start the machine in the no-load state, and the cleaning liquid must be poured into the cleaning tank according to the liquid level in the instructions for use before starting.

6. The

object to be cleaned shall not be in contact with the bottom of the tank, and the workpiece shall be put into the basket for cleaning.

7. The cleaning solution shall not be

strong acid or alkaline, and flammable solution shall not be used in the absence of reliable safety measures.

8. The temperature of the cleaning

solution will increase with the continuous working time, and the continuous working time of the cleaning machine should not exceed 8 hours.

9. If you find that there is water leakage in the cleaning tank, you should immediately shut down and stop using it, and contact the seller after emptying the cleaning liquid.

10. It is not allowed to disassemble the machine without authorization.

11. After the cleaning machine with heating device is cleaned, the heater must be turned off first and the cleaning liquid must be cooled before emptying the cleaning solution.

Normal Working Steps:

1. Check whether the power supply is normal, whether the switch is normal

, whether the indicator light and indicator table are normal, and ensure that the cleaning tank is clean.

2. Put in the cleaning

liquid, then turn on the working power, observe whether the reading of the current indicator meter is between 80-100, the temperature of the cleaning solution is between 40-60 °C, and at the same time, there will be tiny bubbles in the sink and accompanied by a "squeak, squeak" sound, which means that normal cleaning has begun. 3. Insulating gloves must be worn during ultrasonic cleaning.

4. The cleaning objects can not be placed directly at the bottom of the cylinder, so as not to affect the cleaning effect, and should be placed in a special cleaning basket or using the method of zero assembly.

5. The height of the cleaning solution will also affect the cleaning quality, and the best position of the cleaning position of different objects should be explored (note: the volume ratio of the cleaning solution to the cleaning tank is 3/4). 6. Do not turn on the machine when there is no cleaning liquid in the cylinder, so as not to damage the transducer. 7. When not used for a long time, the machine should be kept in a dry place.

8. Put the workpiece tray into the ultrasonic cleaning tank for liquid cleaning

9. The working time is 1-2 minutes, manual cleaning - gently clean the surface of the workpiece (nylon brush) with a tool to ensure that the surface of the workpiece and the inner hole are clean (note: if there are impurities in the hole, spray with a high-pressure air gun, and then put it into the cleaning solution for cleaning).

10. Prevent the workpiece from scratching the surface and losing it during the cleaning process, and ensure the integrity of the number of workpieces

Related News

How to maintain the ultrasonic cleaner?

Check whether the surface of the equipment is clean and clean;

Safety operation procedures for ultrasonic cleaners

The environment around the cleaning machine should be clean, dry and free of strong corrosive gases, and avoid violent vibration.

What are the advantages of ultrasonic cleaner cleaning?

The main advantages of ultrasonic cleaner: high-precision cleaning, fast and efficient, labor saving, good consistency and many other advantages. Ultrasonic cleaning equipment adopts the principle of ultrasonic cleaning, which can achieve the cleaning effect of comprehensive cleanliness of objects, especially for deep holes, blind holes, concave and convex groove cleaning, which is an ideal equipment, and does not affect the material and accuracy of any object.